Unused pins on H6 Allwinner SoC

by circuit_noob533   Last Updated August 13, 2019 21:25 PM - source

I am looking at a reference design for the allwinner H6 SoC. My question is pretty straightforward. Why does pin B3 need to be powered if the EPHY pins are unused. Additionally, pin B4 is being pulled down through the use of a 6k ohm resistor(incorrect assumption). [These have been answered]

What would you do regarding EPHY pins? Follow the design reference, include 50-150k Ohm Pu resistors, or include 50 Ohm pu resistors in the EPHY pins like Passerby recommends here.

enter image description here

Answers 1

Even though the PHY isn't being used by the board, it still needs to be powered so it doesn't disrupt the rest of the chip system internally.

It is possible to design chips so that PHYs are on their own power islands that can be shut off, but this takes area and is hard to verify. The PHY probably does have an internal power-down mode that you can select to minimize its current.

the EPHY-RTX resistor isn't a pull-down. It's a bias reference for internal current and voltage sources that the PHY needs to work. Since the PHY is powered up it likely still needs this reference to operate, even when unused.

I don't think you need to do anything with the TX and RX pins at all. They have internal termination that will keep them from doing anything nasty.

August 13, 2019 21:05 PM

Related Questions

Pull up resistor array for data bus

Updated August 17, 2015 17:10 PM

NPN BJT non-inverting simple amplifier

Updated June 29, 2016 08:10 AM