Switching off dimmable LED flashes then switches back on

by Dave   Last Updated October 19, 2019 13:21 PM - source

I tried to swap out a 70W 240V incandescent bulb with a dimmable 8.8W 220-240V LED. The switch is a dimmer switch, which probably has an old leading edge driver (the building is old).

This mostly worked fine; the bulb switches on to full brightness and can be dimmed (though not especially dim). However after leaving the bulb on for some time, it refused to switch off. The bulb would dim down to almost off, strobe at about 2-3Hz at low brightness for a couple of seconds, then switch back on to full brightness. After trying a few times, I have swapped it back to the old bulb.

On another circuit with the same type of dimmer, I swapped out a cluster of 3× 50W incandescent bulbs for 3× 4.7W dimmable LEDs with no (apparent) problems.

The dimmer switch is an unusual type which I haven't been able to find online:

dimmer switch with black dot in centre

The black dot in the middle seems to be a rolling ball (the rest is immobile). It functions such that tapping acts as an on/off switch, while "swiping" a finger up or down changes the brightness. Even before trying an LED it sometimes behaved oddly (e.g. gradually switching on then immediately gradually switching off with no further interaction).

From what I have read, it seems that the new bulb is probably below the minimum wattage for the dimmer, but I'm trying to understand why it switches back to full brightness.

Will I need to get the dimmers replaced to make this work? Would a slightly higher wattage LED work fine?

Related Questions

Dimmer capacity for halogen bulb

Updated February 23, 2017 08:21 AM

Energy Saving Bulbs with Dimmer Switch

Updated June 04, 2017 17:21 PM

Is it okay for an electrical switch to get warm?

Updated August 16, 2017 20:21 PM