Murray mower with B&S 500e engine running strange

by Stephen Jones   Last Updated August 14, 2019 00:21 AM - source

I got a Murray mower with a Briggs and Stratton 500e 5 HP engine from a friend. Not sure how long it may have been sitting, but I can start it first or second pull. After it starts, it runs slow, unless I tilt it back until the handle is level with the ground. When it's tilted back it runs like normal, but then it cuts off because it stops getting fuel after a few seconds. I've already cleaned the carb, replaced the gas, checked the fuel filter, checked spring tension on the throttle/choke rod (no actual choke, just a spring attached to a rod to hold the door in the carb open) and that is fine, and I checked the air filter/cleaner "sponge" and that looks clean and the engine runs the same with or without it. Only thing I haven't checked was the spark plug, but I don't think that would be the issue because it runs fine while it's tilted. Does anyone have any idea? Or should I just rebuild the entire engine?



Related Questions



Toro ready start lawn mower dead

Updated April 14, 2017 15:21 PM

Why won't my weed whacker keep running?

Updated June 10, 2016 08:09 AM

Lawn Mower (probably) Electrical Problem

Updated June 10, 2016 08:09 AM

Mower barely runs and has blue exhaust

Updated August 21, 2017 05:21 AM