Increasing the Maximum Shank Dia

by Sky High   Last Updated September 19, 2018 16:21 PM - source

There is a device in my head that I know must exist, but I can't seem to find it.

I own a drill. Kinda small. It has a small chuck so the shank dia of the drill bits that I can use is limited. Is there a way around this limitation?

I figure there must be a device that is basically a large chuck connected to a thin shank which can fit in the chuck of my drill, effectively allowing me to use drill bits with greater dias.

Links to where I can purchase this imaginary device would be appreciated.

Related Questions

Universal Drill Bit Converter

Updated September 20, 2018 04:21 AM

Corded vs Cordless Drill

Updated May 15, 2015 22:09 PM

What units are the clutch settings on a drill?

Updated December 13, 2016 08:09 AM

Is it bad to leave batteries in my cordless tools?

Updated March 28, 2017 20:21 PM