Hydronic Heating and DHW on boiler

by Michael   Last Updated October 11, 2018 12:21 PM - source

I have Triple AQUASTAT relay L8124A Honeywell controller on my hydronic heating boiler. It is setup like this for hot water heater as well. I don't have use it for hot water, I have electric hot water heater. How do I stop it from running the boiler to keep the temp for the hot water. I only want it running to provide heating and operate by room thermostat, by not for hot water.

If I turned down the low to 120 or whatever the lowest is, and Diff as well lowest set, will it eliminated the DHW coil? How it will affect on heating?

Could I, some how, bypass the Lo limit or disconnect wire from sensor?

Can you advise? Thanks!

Tags : boiler hydronic

Related Questions

pressure in boiler getting too high

Updated June 02, 2016 08:09 AM

Slant/Fin Victory II Boiler - How do I turn on?

Updated October 28, 2017 17:21 PM

Use CLR to clean stuck bleeder valve

Updated March 30, 2019 17:21 PM