How can I wire a microusb to a MIMXRT1062DVL6A?

by Espresso   Last Updated October 20, 2019 01:25 AM - source

I've never touched a barebones microcontroller before. I've been toying around with an Arduino and Teensy for a few years now. Recently I've been itching to ditch the comfort of those buttercup modules and begin using standalone MCUs. The chip I'm looking at is NXP's ARM Cortex-M7 MIMXRT1062DVL6A. I know there are chips in the market that are less complex, but my question depending on if I'm able to phrase it properly could be generalized to any MCU. I want to know how I can upload code I've written into the device's memory. Specifically via MicroUSB. I've tried looking through the datasheet, but frankly, I don't know where to start. I was wondering if there's a programmer that needs to be installed between the MicroUSB and MCU. Also, I'm curious if when working with MCUs is the datasheet and manual the best documentation for understanding the MCU or are there additional sources I should look into?



Related Questions


Programming SRAM over SWD

Updated August 15, 2016 08:10 AM

Difference between ARM A and M series processors?

Updated January 19, 2018 18:25 PM

Strange behaviour using PWM on CortexM3

Updated March 27, 2015 14:24 PM


Can Tiva C run code from SRAM?

Updated May 20, 2015 03:10 AM